Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


The intelligent tester can be used at step 4.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK TIRE PRESSURE WARNING LIGHT CONDITION
      1. Turn the ignition switch to the ON position.

      2. Record the condition of the tire pressure warning light in the combination meter.

      3. Refer to the TIRE PRESSURE WARNING LIGHT CHART section of the DIAGNOSIS SYSTEM when checking the condition of the tire pressure warning light (Click here ).


      NEXT


      4.DTC CHECK AND CLEAR


        .
        DTC OUTPUT: GO TO STEP 5

        .
        DTC NOT OUTPUT: GO TO STEP 6

        5.DTC CHART


          .
          GO TO STEP 8

          6.PROBLEM SYMPTOM CONFIRMATION


            .
            SYMPTOM DOES NOT OCCUR: GO TO STEP 7

            .
            SYMPTOM OCCURS: GO TO STEP 8

            7.CIRCUIT INSPECTION WITH TROUBLESHOOTING
            1. Refer to PRECAUTION (Click here ).

            2. Refer to SYSTEM DESCRIPTION (Click here ).

              1. Initial check.

              2. Tire pressure warning light chart.

            3. Set the tire pressures to the appropriate specified values.

            4. Perform initialization (Click here ).

            5. Perform test mode procedure (Click here ).

              1. Check for a DTC (Click here ).

              2. Clear the DTC.

              3. Identify transmitter corresponding to DTC.

            6. Perform initialization (Click here ).

            7. Perform registration the transmitter ID (Click here ).

            8. Check the terminals of ECU (Click here ).

            9. Refer to DATA MONITOR / ACTIVE TEST (Click here ).


            NEXT


            8.REPAIR

              NEXT


              9.CONFIRMATION TEST
              1. Check for a DTC (Click here ).

              2. Perform initialization (Click here ).

              3. Confirm that the initialization has been completed.


              NEXT

              END