DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic):
|
|
| P2103 | Either of following conditions is met (1 trip detection logic):
|
|
| Related DTCs | P2102: Throttle Actuator Current (Low Current) P2103: Throttle Actuator Current (High Current) |
| Required Sensors/Components (Main) | Throttle actuator (throttle body assembly) |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | P2102: 2 seconds P2103: 0.6 seconds or conditions met 25 times |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Electric throttle actuator | ON |
| Electric throttle actuator drive duty cycle | 80% or more |
| Electric throttle actuator power supply voltage | 8 V or higher |
| Motor current change during latest 0.016 seconds | less than 0.2 A |
| Throttle actuator | ON |
| Either of the following conditions 1 or 2 is met: | - |
| 1. Electric throttle actuator power supply voltage | 8 V or higher |
| 2. Electric throttle actuator power | ON |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Full-close control | OFF |
| Throttle actuator current | Less than 0.5 A |
| Either of following conditions met: | A or B |
| A. Hybrid IC diagnosis signal | Fail |
| B. Hybrid IC current limiter port | Fail |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT THROTTLE BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle body assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE BODY - ECM) |
Disconnect the throttle body assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T1-2 (M+) - E4-5 (M+) | Always | Below 1 Ω |
| T1-1 (M-) - E4-4 (M-) | Always | Below 1 Ω |
| Tester Connections | Condition | Specified Conditions |
| T1-2 (M+) or E4-5 (M+) - Body ground | Always | 10 kΩ or higher |
| T1-1 (M-) or E4-4 (M-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE BODY ASSEMBLY (THROTTLE VALVE) |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||