METER / GAUGE SYSTEM > Tachometer Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (TACHOMETER OPERATION) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| TachoMeter Operation | Tachometer | OFF/0/1000/2000/3000/4000/5000/ 6000/7000 rpm | Perform the test with the vehicle stopped and the engine idling. |
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (ENGINE RPM) |
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Rpm | Engine speed/ Min.: 0, Max.: 12750 | Approximately same as actual engine speed (when engine is running) | Unit: rpm |
|
| ||||
| OK | |
| 4.CHECK SFI SYSTEM |
Check if a SFI DTC is output.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for 1GR-FE) | B |
| DTC is output (for 2TR-FE) | C |
|
| ||||
|
| ||||
| A | ||
| ||