CYLINDER HEAD (for Bank 2 2WD) > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DRAIN ENGINE COOLANT |
![]() |
Remove the service hole cover from the engine under cover.
Install a vinyl hose onto the drain on the radiator side.
Fix the vinyl hose with tape.
![]() |
Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.
Remove the radiator cap.
Drain the coolant from the reservoir tank.
Tighten the 3 drain plugs.
Remove the vinyl hose from the radiator.
| 3. DRAIN ENGINE OIL |
Remove the engine under cover seal No. 3.
Remove the oil pan drain plug and drain the engine oil.
Clean the oil pan drain plug and install it with a new gasket.
| 4. REMOVE ENGINE ASSEMBLY |
| 5. REMOVE TIMING CHAIN OR BELT COVER SUB-ASSEMBLY |
| 6. REMOVE CHAIN SUB-ASSEMBLY |
| 7. REMOVE NO.1 COOL AIR INLET |
Remove the 2 bolts, then remove the cool air inlet.
| 8. REMOVE FRONT NO.2 EXHAUST PIPE ASSEMBLY |
| 9. REMOVE MANIFOLD STAY |
Remove the 3 bolts, then remove the exhaust manifold stay.
| 10. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH |
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, then remove the exhaust manifold and gasket.
| 11. REMOVE INTAKE MANIFOLD |
Disconnect the 6 fuel injector connectors.
![]() |
Remove the 10 bolts, then remove the intake manifold and gasket.
| 12. REMOVE WATER BY-PASS JOINT REAR |
Disconnect the engine coolant temperature sensor connector.
Disconnect the heater hose.
![]() |
Remove the 2 bolts and 4 nuts, then remove the water by-pass joint RR and 2 gaskets.
Remove the O-ring from the water outlet hose.
| 13. REMOVE NO.1 CHAIN VIBRATION DAMPER |
Remove the 2 bolts, then remove the chain vibration damper No. 1.
| 14. REMOVE CAMSHAFT TIMING GEARS AND NO.2 CHAIN (for Bank 2) |
![]() |
While pushing down the chain tensioner No. 2, insert a pin of φ 10. mm (0.039 in.) into the hole to fix it.
![]() |
Hold the hexagonal portion of the camshaft with a wrench.
Remove the 2 bolts, then remove the camshaft timing gear, camshaft timing gear assembly and timing chain No. 2.
| 15. REMOVE NO.2 CHAIN TENSIONER ASSEMBLY |
![]() |
Remove the bolt, then remove the chain tensioner No. 3.
| 16. REMOVE CAMSHAFTS |
![]() |
Using several steps, uniformly loosen and remove the 16 bearing cap bolts in the sequence shown in the illustration.
Remove the 8 bearing caps and 2 camshafts.
| 17. REMOVE CYLINDER HEAD LH |
Remove the bolt, then separate the ground cable.
![]() |
Using several steps, remove the 2 cylinder head bolts on the cylinder head in the sequence shown in the illustration.
![]() |
Using several steps, uniformly loosen the 8 cylinder head bolts on the cylinder head with a 10 mm bi-hexagon wrench in the sequence shown in the illustration. Remove the 8 cylinder head bolts and 8 plate washers.
![]() |
Lift the cylinder head from the dowels on the cylinder block, and place the cylinder head on wooden blocks on a bench.
| 18. REMOVE NO.2 CYLINDER HEAD GASKET |