Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

DTC    C1203    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The circuit sends TRAC, A-TRAC and VSC control information from the skid control ECU (master cylinder solenoid) to the ECM, and engine control information from the ECM to the skid control ECU (master cylinder solenoid) via the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
C1203
Information relating to engine drive source or destination stored in ECM does not match that stored in skid control ECU (master cylinder solenoid).
  1. CAN communication system
  2. ECM

INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2.CHECK DTC (ENGINE CONTROL SYSTEM)
  1. Check if any DTC is recorded for the engine control system (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
REPLACE ECM (Click here)
A

GO TO ENGINE CONTROL SYSTEM (Click here)