Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) > VSC Buzzer Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.
The combination meter has a built-in VSC warning buzzer:
  1. Sounds intermittently to inform the driver if the temperature of brake actuator assembly has increased excessively due to continuous operation of TRAC and AUTO LSD.
  2. Sounds intermittently to inform the driver that the VSC is operating.

WIRING DIAGRAM


C231258E04


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform the zero point calibration (Click here).

1.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2.PERFORM ACTIVE TEST USING TECHSTREAM (BUZZER)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    VSC warning buzzer
    Buzzer OFF/ON
    The buzzer can be heard

  1. Check that the buzzer sounds or stops in accordance with the Techstream.
    Result 
    Result
    Proceed to
    Buzzer does not sound or stop
    A
    Buzzer sounds and stops
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A


3.REPLACE COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Replace the combination meter (Click here).


NEXT


4.PERFORM ACTIVE TEST USING TECHSTREAM (BUZZER)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    VSC warning buzzer
    Buzzer OFF/ON
    The buzzer can be heard

  1. Check that the buzzer sounds or stops in accordance with the Techstream.
    Result 
    Result
    Proceed to
    Buzzer does not sound or stop
    A
    Buzzer sounds and stops
    B



B
END
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)