Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

DTC    C1381    Acceleration Sensor Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the deceleration sensor) are stored.
These DTCs are also stored when calibration has not been completed.

DTC Code
DTC Detection Condition
Trouble Area
C1381
At a vehicle speed of more than 3 km/h (2 mph), the deceleration sensor power source malfunction signal is received for 10 seconds or more.
  1. ECU-IG fuse
  2. Yaw rate and deceleration sensor
  3. Yaw rate and deceleration sensor power source circuit

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.INSPECT YAW RATE AND DECELERATION SENSOR (IG, GND TERMINAL)
  1. Disconnect the yaw rate and deceleration sensor connector.



    C208309E30
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    Y2-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Y2-1 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Yaw Rate and Deceleration Sensor)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.RECONFIRM DTC
  1. Reconnect the yaw rate and deceleration sensor connector.

  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Perform a road test.

  1. Check if the same DTC is output (Click here).

Result 
Result
Proceed to
DTC C1381 is not output
A
DTC C1381 is output
B


B
REPLACE YAW RATE AND DECELERATION SENSOR (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)