Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION

This DTC is stored when referencing data becomes impossible due to an internal malfunction in the ECU.

DTC Code
DTC Detection Condition
Trouble Area
C2176/76
Malfunction in the tire pressure warning ECU internal circuit.
Tire pressure warning ECU

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced.

1.CLEAR DTC
  1. Turn the ignition switch OFF.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON and the Techstream on.

  1. Clear the DTC (Click here).


NEXT


2.CHECK DTC
  1. Turn the ignition switch OFF.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON and the Techstream on.

  1. Check for DTC.
    Result 
    Result
    Proceed to
    DTC C2176 is output
    A
    DTC C2176 is not output
    B



B
USE SIMULATION METHOD TO CHECK
A

REPLACE TIRE PRESSURE WARNING ECU (Click here)