Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

DTC    C1436    Yaw Rate Sensor Malfunction

for Preparation Click here


DESCRIPTION

Refer to DTC C1419 and C1435 .

DTC Code
DTC Detection Condition
Trouble Area
C1436
Either condition is met:
  1. With the vehicle stationary, the yaw rate and deceleration sensor output value is not 0°/s.
  2. An abnormal comparison value.
  1. Yaw rate and deceleration sensor
  2. Sensor installation

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
  2. Check the yaw rate and deceleration sensor signal after replacement (Click here).

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.READ VALUE USING TECHSTREAM (YAW RATE SENSOR)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Yaw Rate Sensor
    Yaw rate and deceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s
    0°/s: Vehicle stationary
    -128 to 0°/s: Right turn
    0 to 127°/s: Left turn
    -

  1. Check that the yaw rate and deceleration sensor output value is displayed on the Techstream.

    Result 
    Result
    Proceed to
    NG
    Yaw rate and deceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning
    A
    Yaw rate and deceleration sensor output value is not 0°/s when vehicle is stationary
    B
    OK
    C



B
REPLACE YAW RATE AND DECELERATION SENSOR (Click here)

C
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A


3.CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Turn the ignition switch off.

  1. Check that the yaw rate and deceleration sensor is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE YAW RATE AND DECELERATION SENSOR (Click here)