VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) > Brake Warning Light does not Come ON |
| 1.INSPECT BRAKE WARNING LIGHT |
Disconnect the S1 control ECU connector.
Turn the ignition switch to ON.
Check that the BRAKE warning light comes on.
|
| ||||
| OK | ||
| ||
| 2.CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Lamp Brake) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Brake | Brake warning light | OFF/ON | Perform the test with the vehicle stopped and the engine idling |
Check that the BRAKE warning light on the combination meter assembly turns on or off in accordance with the Techstream operation.
|
| ||||
| OK | ||
| ||