VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) > Slip Indicator Light Remains ON |

| 1.CHECK THAT SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check the skid control ECU connector connection.
|
| ||||
| OK | |
| 2.CHECK DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 3.INSPECT BATTERY |
Inspect the battery voltage.
| Result | Proceed to |
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 2TR-FE) | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
|
| ||||
| OK | |
| 5.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Lamp Slip) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Slip | Slip indicator light | OFF/ON | Perform the test with the vehicle stopped and the engine idling |
Check that the slip indicator light on the combination meter assembly turns on or off in accordance with the Techstream operation.
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL) |
Disconnect the S1 skid control ECU connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S1-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU) |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (GND TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S1-1 (GND1) - Body ground | Always | Below 1 Ω |
| S1-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU) |
Reconnect the S1 skid control ECU connector.
|
| ||||
| OK | ||
| ||