Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) > Slip Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

Refer to Slip Indicator Light Remains ON .

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the skid control ECU (master cylinder solenoid), perform calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT SLIP INDICATOR LIGHT
  1. Disconnect the skid control ECU skid control ECU (master cylinder solenoid) connector.

  1. Turn the ignition switch to ON.

  1. Check that the Slip Indicator light comes on.

    OK:
    Slip Indicator light comes on.



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)  

2.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


3.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Lamp Slip)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.


Combination Meter 
Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. Lamp Slip
Slip indicator light
OFF/ON
Perform the test with the vehicle stopped and the engine idling
  1. Check that the Slip indicator light on the combination meter assembly turns on or off in accordance with the Techstream operation.

    OK:
    The Slip indicator light turns on or off in accordance with the Techstream operation.



NG
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)