Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster) > VSC OFF Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

Refer to VSC OFF Indicator Light Remains ON .

WIRING DIAGRAM

Refer to VSC OFF Indicator Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the brake actuator assembly, perform calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. VSC OFF)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.


Combination Meter 
Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. VSC OFF
VSC OFF indicator light
OFF/ON
Perform the test with the vehicle stopped and the engine idling
  1. Check that the VSC OFF indicator light on the combination meter assembly turns on or off in accordance with the Techstream operation.

    OK:
    The VSC OFF indicator light turns on or off in accordance with the Techstream operation.



NG
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


3.INSPECT SKID CONTROL ECU (CSW TERMINAL)
  1. Disconnect the S1 skid control ECU (brake actuator assembly) connector.



    C237288E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    S1-30 (CSW) - Body ground
    VSC OFF switch not pushed in
    10 kΩ or higher
    VSC OFF switch pushed in
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU (Brake Actuator Assembly))

  1. Reconnect the S1 skid control ECU (brake actuator assembly) connector.



NG
Go to step 4
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

4.INSPECT VSC OFF SWITCH
  1. Remove the VSC OFF switch (Click here).



    C237120E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 4
    Switch is not pushed
    10 kΩ or higher
    Switch is pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (VSC OFF Switch)



NG
REPLACE VSC OFF SWITCH (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR