VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) > AUTO LSD Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (Indicat. Auto LSD) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Auto LSD | AUTO LSD indicator light | OFF/ON | Perform the test with the vehicle stopped and the engine idling |
Check that the AUTO LSD indicator light on the combination meter assembly turns on or off in accordance with the Techstream operation.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CSW TERMINAL) |
Disconnect the S1 skid control ECU (master cylinder solenoid) connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S1-9 (CSW) - Body ground | VSC OFF switch not pushed in | 10 kΩ or higher |
| VSC OFF switch pushed in | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU) |
Reconnect the S1 skid control ECU (master cylinder solenoid) connector.
|
| ||||
| OK | ||
| ||
| 4.INSPECT VSC OFF SWITCH |
Remove the VSC OFF switch (Click here).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 - 4 | Switch is not pushed | 10 kΩ or higher |
| Switch is pushed | Below 1 Ω |
| *a | Component without harness connected (VSC OFF Switch) |
|
| ||||
| OK | ||
| ||