Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light Remains ON

for Preparation Click here


DESCRIPTION

If any of the following conditions are detected, the ABS warning light remains on:
  1. The ECU connector is disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open or short in the CAN communication line between the combination meter and the skid control ECU.

HINT:
The Techstream cannot be used when there is a malfunction in the skid control ECU.


WIRING DIAGRAM


C195149E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the VSC actuator assembly, perform zero point calibration (Click here).
  2. Make sure the skid control ECU is not in test mode before proceeding.
  3. Before using these procedures, first check other DTCs which may cause the ABS warning light to remain on.

1.INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT CONNECTOR CONNECTION CONDITION
  1. Check the skid control ECU connector connection condition.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND)


    C152724E03
  1. Disconnect the A17 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A17-9 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A17-1 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.PERFORM ACTIVE TEST USING TECHSTREAM (ABS WARNING LIGHT)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select the Active Test mode and operate the ABS warning light using the Techstream.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Light
    ABS warning light
    ON / OFF
    Observe combination meter

  1. Check that the ABS warning light turns on and off in the combination meter when using the Techstream.

    OK:
    The ABS warning light turns on and off in accordance with the Techstream operation.

    HINT:
    When the ABS warning light remains illuminated, there may be an open in the wire harness of the combination meter or abnormalities in the meter circuit.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)