Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver receives a reverse signal from the park / neutral position and information about the navigation antenna, and then adjusts vehicle position.

WIRING DIAGRAM


E138079E01


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER


    E146425E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K6-5 (REV) - Body ground
    Ignition switch ACC, shift lever in R position
    11 to 14 V
    Ignition switch ACC, shift lever in P position
    Below 1 V

    Result 
    Result
    Proceed to
    NG
    A
    OK (for Column Shift Type)
    B
    OK (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A


2.CHECK HARNESS AND CONNECTOR (PARK / NEUTRAL POSITION SWITCH - NAVIGATION RECEIVER AND BATTERY)
E138080E01
  1. Disconnect the K6 receiver connector.

  1. Disconnect the D35 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D35-1 (RL) - K6-5 (REV)
    Always
    Below 1 Ω
    D35-1 (RL) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D35-2 (RB) - Body ground
    Ignition switch OFF
    Below 1 V
    Ignition switch ACC
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK / NEUTRAL POSITION SWITCH


    E120122E12
  1. Disconnect the D35 switch connector

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Shift Lever Position
    Specified Condition
    2 (RB) - 1 (RL)
    Ignition switch ACC, shift lever in R position
    Below 1 Ω
    Ignition switch ACC, shift lever in P position
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for A750E)
    B
    NG (for AB60F)
    C
    NG (for A750F)
    D
    NG (for AB60E)
    E



B
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

C
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

D
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

E
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)