AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab) > Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.INSPECT STEREO COMPONENT AMPLIFIER |
![]() |
Disconnect the K15 amplifier connector.
Measure the voltage.
Jack up the drive wheels.
Move the shift lever to the neutral position.
Turn the ignition switch to the ON position.
![]() |
Measure the voltage between terminal SPD of the stereo component amplifier and body ground when the drive wheels are turned slowly.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the K15 amplifier connector.
Disconnect the J28 meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K15-11 (SPD) - J28-35 (+S) | Always | Below 1 Ω |
| K15-11 (SPD) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||