Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned LOCK, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch LOCK, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT BUMPER COVER
  1. for Steel Type Bumper:
    Remove front bumper cover (Click here).

  1. for Resin Type Bumper:
    Remove front bumper cover (Click here).



4. REMOVE RADIATOR ASSEMBLY
  1. for 1GR-FE:
    Remove the radiator (Click here).

  1. for 2UZ-FE:
    Remove the radiator (Click here).

  1. for 3UR-FE:
    Remove the radiator (Click here).

  1. for 3UR-FBE:
    Remove the radiator (Click here).



5. DISCONNECT DISCHARGE HOSE


E142186
  1. Remove the bolt and disconnect the discharge hose from the cooler condenser.

    NOTICE:
    1. When removing the bolt, do not allow any tools to contact the pipe.
    2. When removing the bolt, hold a part of the pipe near the connector.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


E142187
  1. Remove the 2 bolts and air conditioning tube and accessory from the cooler condenser.

    NOTICE:
    1. When removing the bolt, do not allow any tools to contact the pipe.
    2. When removing the bolt, hold a part of the pipe near the connector.

  1. Remove the O-ring from the air conditioning tube and accessory.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



7. REMOVE COOLER CONDENSER ASSEMBLY
  1. Remove the 2 bolts.



    E142188
  1. Remove the cooler condenser, as shown in the illustration.



8. REMOVE COOLER DRYER


    I030086E01
  1. Using a 14 mm socket hexagon wrench, remove the cap from the modulator.



    I032475E01
  1. Remove the O-ring from the cap.



    E050386E01
  1. Using pliers, remove the cooler dryer.