DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-D6*1 | When either of the following conditions is met:
|
|
| 01-D7*2 | When either of the following conditions is met:
|
| 1.CHECK NAVIGATION RECEIVER POWER SOURCE CIRCUIT |
Refer to the navigation receiver power source circuit (Click here).
If the power source circuit is operating normally, proceed to the next step.
| NEXT | |
| 2.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| AVN | Navigation receiver |
| DSP-AMP | Stereo component amplifier |
| NEXT | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
| Component | Proceed to |
| Navigation receiver (AVN) | Navigation receiver power source circuit (Click here) |
| Stereo component amplifier (DSP-AMP) | Stereo component amplifier power source circuit (Click here) |
| NEXT | |
| 4.INSPECT NAVIGATION RECEIVER |
![]() |
Disconnect the K18 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5 (ATX+) - 15 (ATX-) | Always | 60 to 80 Ω |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver and the component which has stored this code.
Disconnect all connectors between the navigation receiver and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the navigation receiver and the component which has stored this code.

|
| ||||
| OK | |
| 6.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | ||
| ||