Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

NAVIGATION SYSTEM (for Double Cab) > Navigation Receiver Assembly Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


    E138069E03
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component shown by the sub-code.

    HINT:
    1. "140 (navigation receiver)" is the component shown by the sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.

    Component table 
    Component
    Proceed to
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)
    If the power source circuit is operating normally, proceed to the next step.


NEXT


3.CHECK NAVIGATION RECEIVER
E138070E01
  1. Disconnect the K18 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (ATX+) - 15 (ATX-)
    Always
    60 to 80 Ω

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A


4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver and the component shown by the sub-code.

    1. Disconnect all connectors between the navigation receiver and the component shown by sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the navigation receiver and the component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E138055E01



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A

END