DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-D6*1 | When either of the following conditions is met:
|
|
| 01-D7*2 | When either of the following conditions is met:
|
| 1.CHECK RADIO RECEIVER POWER SOURCE CIRCUIT |
Refer to the radio receiver power source circuit (Click here).
If the power source circuit is operating normally, proceed to the next step.
| NEXT | |
| 2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
Enter the diagnostic mode.

Press the preset switch "3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical address |
| Stereo component amplifier | 440 |
| "Bluetooth" handsfree module | 19D |
| NEXT | |
| 3.CHECK COMPONENT WHICH HAS STORED THIS CODE |
Select the component which has stored this code.
| Component | Proceed to |
| "Bluetooth" handsfree module (for Column Shift Type) | A |
| "Bluetooth" handsfree module (for Floor Shift Type) | B |
| Except "Bluetooth" handsfree module | C |
|
| ||||
|
| ||||
| C | |
| 4.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
| Component | Proceed to |
| Stereo component amplifier | Stereo component amplifier power source circuit (Click here) |
| NEXT | |
| 5.INSPECT RADIO RECEIVER |
![]() |
Disconnect the K4 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K4-5 (ATX+) - K4-15 (ATX-) | Always | 60 to 80 Ω |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 6.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component which has stored this code.
Disconnect all connectors between the radio receiver and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver and the component which has stored this code.

|
| ||||
| OK | |
| 7.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | ||
| ||