Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab)

AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab) > Radio Receiver Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E146479E01

  1. Press the preset switch "3" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

HINT:
  1. "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
  1. For details of the DTC display, refer to "DTC CHECK/CLEAR" (Click here).


NEXT


2.CHECK COMPONENT SHOWN BY SUB-CODE
  1. Select the component which has stored this code.

    HINT:
    The "Bluetooth" handsfree module is built into the radio receiver. If there is a problem between the "Bluetooth" handsfree module and radio receiver, replace the radio receiver.


    Component table: 
    Component
    Proceed to
    "Bluetooth" handsfree module (for Column Shift Type)
    A
    "Bluetooth" handsfree module (for Floor Shift Type)
    B
    Except "Bluetooth" handsfree module
    C



A
REPLACE RADIO RECEIVER (Click here)

B
REPLACE RADIO RECEIVER (Click here)
C


3.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.

    Component table: 
    Component
    Proceed to
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)

    1. If the power source circuit is operating normally, proceed to the next step.


NEXT


4.INSPECT RADIO RECEIVER


    E145928E01
  1. Disconnect the K4 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K4-5 (ATX+) - K4-15 (ATX-)
    Always
    60 to 80 Ω

    Result: 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER (Click here)

C
REPLACE RADIO RECEIVER (Click here)
A


5.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  1. For details of the connectors, refer to the "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

    1. Disconnect all connectors between the radio receiver and the component shown by the sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E138055E03



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.

    Result: 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER (Click here)

C
REPLACE RADIO RECEIVER (Click here)
A

END