DTC C1336/39 Zero Point Calibration of Acceleration Sensor Undone |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1336/39 | When the vehicle is driven without completion of zero point calibration. |
|
| 1.CHECK SENSOR USING TEST MODE PROCEDURE |
Perform the test mode procedure (Click here).
Check if any of the test mode DTCs are recorded.
| Result | Proceed to |
| DTC (test mode DTC) is not output | A |
| DTC (test mode DTC) is output | B |
|
| ||||
| A | |
| 2.CHECK YAW RATE SENSOR INSTALLATION |
Check that the yaw rate sensor has been installed properly (Click here).
|
| ||||
| OK | |
| 3.PERFORM DECELERATION SENSOR ZERO POINT CALIBRATION |
Perform zero point calibration of the deceleration sensor (Click here).
| NEXT | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||