VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light does not Come ON |
| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.INSPECT CONNECTOR CONNECTION CONDITION |
Check the skid control ECU connector connection condition.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
Disconnect the A17 ECU connector.
![]() |
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A17-9 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| A17-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Active Test mode and operate the SLIP indicator light using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slip Indicator Light | SLIP indicator light | ON / OFF | Observe combination meter |
Check that the SLIP indicator light turns on and off in the combination meter when using the Techstream.
|
| ||||
| OK | |
| 5.INSPECT VSC OFF SWITCH |
![]() |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 - 9 | Switch is pressed | Below 1 Ω |
| Switch is not pressed | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH AND BODY GROUND) |
![]() |
Disconnect the A17 ECU connector.
Disconnect the J22 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-13 (CSW) - J22-9 | Always | Below 1 Ω |
| A17-13 (CSW) - Body ground | Always | 10 kΩ or higher |
| J22-6 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||