VEHICLE STABILITY CONTROL SYSTEM > AUTO LSD Indicator Light Remains ON |

| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (AUTO LSD INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Active Test mode and operate the AUTO LSD indicator light using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Auto LSD Indicator Light | AUTO LSD indicator light | ON / OFF | Observe combination meter |
Check that the AUTO LSD indicator light turns on and off in the combination meter when using the Techstream.
|
| ||||
| OK | |
| 3.INSPECT VSC OFF SWITCH |
![]() |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 - 9 | Switch is pressed | Below 1 Ω |
| Switch is not pressed | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
![]() |
Disconnect the A17 ECU connector.
Disconnect the J22 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-13 (CSW) - J22-9 | Always | Below 1 Ω |
| A17-13 (CSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||