Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab)

AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab) > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone to the radio receiver.
It also supplies power from the radio receiver to the microphone.

WIRING DIAGRAM


E147078E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TSW- - MGND)


    B110782E17
  1. Disconnect the K9 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K9-3 (TSW-) - K9-6 (MGND)
    Always
    Below 1 Ω
    K9-3 (TSW-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER)


    E145927E01
  1. Disconnect the W7 microphone connector.

  1. Disconnect the K9 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    W7-10 (ACC) - K9-7 (MCVD)
    Always
    Below 1 Ω
    W7-9 (MI1+) - K9-2 (MIC+)
    W7-8 (MIC-) - K9-1 (MIC-)
    W7-10 (ACC) - Body ground
    Always
    10 kΩ or higher
    W7-9 (MI1+) - Body ground
    W7-8 (MIC-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK RADIO RECEIVER (MCVD VOLTAGE)


    E145932E01
  1. Disconnect the K9 receiver connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K9-7 (MCVD) - Body ground
    Ignition switch ON
    4 to 6 V

    Result: 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO RECEIVER (Click here)

C
REPLACE RADIO RECEIVER (Click here)
A


4.REPLACE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the microphone with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY
OK

END (MICROPHONE IS FAULTY)