AUDIO AND VISUAL SYSTEM (for CrewMax) > Microphone Circuit between Microphone and Radio Receiver |

| 1.CHECK HARNESS AND CONNECTOR (TSW- - MGND) |
![]() |
Disconnect the K9 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K9-3 (TSW-) - K9-6 (MGND) | Always | Below 1 Ω |
| K9-3 (TSW-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER) |
![]() |
Disconnect the W7 microphone connector.
Disconnect the K9 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| W7-10 (ACC) - K9-7 (MCVD) | Always | Below 1 Ω |
| W7-9 (MI1+) - K9-2 (MIC+) | ||
| W7-8 (MIC-) - K9-1 (MIC-) | ||
| W7-10 (ACC) - Body ground | Always | 10 kΩ or higher |
| W7-9 (MI1+) - Body ground | ||
| W7-8 (MIC-) - Body ground |
|
| ||||
| OK | |
| 3.CHECK RADIO RECEIVER (MCVD VOLTAGE) |
![]() |
Disconnect the K9 receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K9-7 (MCVD) - Body ground | Ignition switch ON | 4 to 6 V |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 4.REPLACE MICROPHONE WITH ANOTHER AND CHECK |
Replace the microphone with a normal one (Click here).
Check if the same problem occurs again.
|
| ||||
| OK | ||
| ||