Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag.

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
  1. Remove the front seat (Click here).



3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
  1. Remove the front seat (Click here).



4. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Manual Seat)


B165525E01
  1. Remove the screw.

  1. Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY
  1. Driver Side:
    Disconnect the 2 connectors and detach the 4 clamps.

  1. Passenger Side:
    Disconnect the connector and detach the clamp.



    B166598
  1. Remove the nut and front seat inner belt.