Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (for Regular Cab)


  1. Install the curtain shield airbag with the 6 bolts.


    B166466

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (for Double Cab)


  1. Install the curtain shield airbag with the 8 bolts.


    B166467

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



3. INSTALL ROOF HEADLINING ASSEMBLY
  1. Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (for Double cab) (Click here).

  1. Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (for regular cab) (Click here).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



5. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).