Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
  1. Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for Double Cab) (Click here).
  2. Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for Regular Cab) (Click here).



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (for Regular Cab)
  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 6 bolts and curtain shield airbag.


    B166466



4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (for Double Cab)
  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 8 bolts and curtain shield airbag.


    B166467