Home › RESTRAINTS › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

When the ignition switch is ON, the center airbag sensor transmits front seat inner belt state signals to the meter ECU through CAN. If the driver seat belt is not fastened, the meter ECU blinks the driver side seat belt warning light. If the seat belt is fastened, the warning light goes off.

WIRING DIAGRAM


B166976E02


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check for DTCs.

    1. for CAN communication system (Click here).

    2. for Airbag system (Click here).
      Result: 
      Result
      Proceed to
      DTC is not output
      A
      CAN system DTC is output
      B
      Airbag system DTC is output
      C



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO AIRBAG SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SEAT BELT WARNING LIGHT)
  1. Operate the Techstream according to the steps on the display and select "Active Test" (Click here).

    Combination Meter: 
    Item
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp D-seat Belt
    Driver side seat belt warning light
    ON or OFF
    -

    OK:
    Driver side seat belt warning light condition can be switched by "Active Test".



NG
REPLACE COMBINATION METER (Click here)
OK


3.REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
  1. Temporarily replace the front seat inner belt LH with a new or normally functioning one (Click here).


NEXT


4.CHECK DRIVER SIDE SEAT BELT WARNING LIGHT
  1. Check the driver side seat belt warning light function (Click here).

    OK:
    Driver side seat belt warning light operates normally.



NG
REPLACE COMBINATION METER (Click here)
OK

END (FRONT SEAT INNER BELT LH IS DEFECTIVE)