Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Vehicle Position Mark is not Updated

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK SD CARD
  1. Check that the SD card is not deformed or cracked.

    OK:
    No deformations or cracks in the SD card.



NG
REPLACE SD CARD
OK


2.CHECK NAVIGATION DISPLAY
  1. Check if a touch scroll can be performed on the map display.

    OK:
    Touch scroll can be performed.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A


3.CHECK VEHICLE SENSOR (OPERATION CHECK)


    E235191E03
  1. Enter the "Function Check/Setting I" and select "Vehicle Signal" (Click here).

  1. While driving the vehicle, compare the "SPEED" indicator to the reading on the speedometer. Check if these readings are equal or almost equal.

    OK:
    The readings are equal or almost equal.



NG
GO TO "Speed signal does not change in navigation check mode" IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END