SFI SYSTEM > MIL Circuit |

| 1.CHECK WHETHER MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the table below.
| Result | Proceed to |
| MIL remains on | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CHECK WHETHER MIL TURNS OFF |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Check if DTCs have been stored (Click here).
If DTCs are output, write them down.
Clear the DTCs (Click here).
Check that the MIL turns off.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J28-5 (CHK) or A24-24 (W) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 5.CHECK THAT MIL IS ILLUMINATED |
Check if the MIL is illuminated when the ignition switch is turned to ON.
|
| ||||
| OK | ||
| ||
| 6.CHECK THAT ENGINE STARTS |
Turn the ignition switch to ON.
Start the engine.
| Result | Proceed to |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 7.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the ECM connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J28-5 (CHK) - A24-24 (W) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||