DTC B2621 Communication Interruption |
| DTC Code | Detection Condition | Trouble Area |
| B2621 | The periodic signal from a specified ECU has stopped. |
|
| 1.CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs of the CAN communication system (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (MAIN BODY ECU COMMUNICATION SIGNAL) |
Use the Data List to check if the main body ECU communication signal is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| J/B | Communication state of main body ECU signal / OK or Interpt | OK: Communication is normal Interpt: Communication is interrupted | - |
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (FRONT POWER SEAT CONTROL ECU AND SWITCH LH COMMUNICATION SIGNAL) |
Use the Data List to check if the front power seat control ECU and switch LH communication signal is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Receive from Seat ECU | Communication state of front power seat control ECU and switch LH signal / OK or Interpt | OK: Communication is normal Interpt: Communication is interrupted | - |
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (COMBINATION METER ECU COMMUNICATION SIGNAL) |
Use the Data List to check if the combination meter ECU communication signal is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Receive from Meter | Communication state of combination meter signal / OK or Interpt | OK: Communication is normal Interpt: Communication is interrupted | - |
|
| ||||
| OK | ||
| ||