Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Illumination for Panel Switch does not Come on with Tail Switch ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)


    E235191E01
  1. Enter the "Function Check/Setting I" mode and select "Vehicle Signal Check Mode" (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch Condition
    Display Condition
    TAIL or HEAD
    ON
    OFF
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)