Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

DTC    B1562    XM Tuner Disconnected (Burst Mode)

for Preparation Click here


DESCRIPTION

The navigation receiver assembly and stereo component tuner assembly are connected by the AVC-LAN plus communication lines.
When an AVC-LAN plus communication error occurs between the navigation receiver assembly and stereo component tuner assembly, this DTC will be stored.

DTC Code
DTC Detection Condition
Trouble Area
B1562
When the master unit deletes the satellite radio tuner from the system components device list due to an AVC-LAN plus communication error.
  1. AVC-LAN plus circuit between display and navigation assembly and stereo component tuner assembly
  2. Stereo component tuner assembly
  3. Navigation receiver assembly
  4. Multi-media interface ECU

HINT:
The navigation receiver assembly is the master unit.


WIRING DIAGRAM


E190580E02


INSPECTION PROCEDURE

NOTICE:
After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC and check if the same trouble occurs again.

    OK:
    No DTC is output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT TUNER)


    E191657E01
  1. Disconnect the K26 navigation receiver assembly connector.

  1. Disconnect the K28 stereo component tuner assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K26-2 (TXO+) - K28-3 (TXI+)
    Always
    Below 1 Ω
    K26-3 (TXI+) - K28-2 (TXO+)
    Always
    Below 1 Ω
    K26-5 (TXO-) - K28-6 (TXI-)
    Always
    Below 1 Ω
    K26-6 (TXI-) - K28-5 (TXO-)
    Always
    Below 1 Ω
    K26-2 (TXO+) - Body ground
    Always
    10 kΩ or higher
    K26-3 (TXI+) - Body ground
    Always
    10 kΩ or higher
    K26-5 (TXO-) - Body ground
    Always
    10 kΩ or higher
    K26-6 (TXI-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT TUNER ASSEMBLY


    E190429E02
  1. Disconnect the K28 stereo component tuner assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K28-2 (TXO+) - K28-3 (TXI+)
    Always
    Below 1 Ω
    K28-5 (TXO-) - K28-6 (TXI-)
    Always
    Below 1 Ω



NG
REPLACE STEREO COMPONENT TUNER ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)