WINDOW DEFOGGER SYSTEM > Rear Window Defogger System does not Operate |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (DEFOGGER RELAY) |
Select the Active Test using the Techstream to generate a control command, and then check that the rear window defogger operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Defogger Relay (Rear) | Rear window defogger relay operation | OFF or ON | - |
|
| ||||
| OK | |
| 2.CHECK INTEGRATION CONTROL AND PANEL (OPERATION) |
Temporarily replace the integration control and panel with a new or normally functioning one.
For Column Shift Type, refer to the following procedures (Click here).
For Floor Shift Type, refer to the following procedures (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||
| 3.INSPECT FUSE (DEFOG) |
Remove the DEFOG H-fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DEFOG H-fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT DEFOGGER RELAY (DEFOG) |
![]() |
Remove the DEFOGGER relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | When battery voltage is not applied between terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | 10 kΩ or higher | |
| 3 - 4 | When battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY - BATTERY AND AIR CONDITIONING AMPLIFIER) |
![]() |
Remove the DEFOGGER relay from the engine room relay block.
Disconnect the J19 air conditioning amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DEFOGGER relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
| DEFOGGER relay terminal 5 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DEFOGGER relay terminal 2 - J19-38 (RDEF) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (REAR WINDOW DEFOGGER - DEFOGGER RELAY AND BODY GROUND) |
![]() |
Disconnect the P9 and P10 defogger connectors.
Remove the DEFOGGER relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P9-1 - DEFOGGER relay terminal 3 | Always | Below 1 Ω |
| P10-1 - Body ground | ||
| DEFOGGER relay terminal 4 - Body ground | ||
| P9-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 7.CHECK AIR CONDITIONING AMPLIFIER (OPERATION) |
Temporarily replace the air conditioning amplifier with a new or normally functioning one (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||