Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

HINT:
  1. Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Column Shift Type) (Click here).
  2. Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Floor Shift Type) (Click here).



4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY


    B160596
  1. Remove the 3 screws and register.



5. REMOVE NO. 1 HEATER TO REGISTER DUCT WITH NO. 2 HEATER TO REGISTER DUCT


  1. Remove the 5 screws and duct.


    B161141



6. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT


    B160598
  1. Remove the 2 screws.

  1. Detach the claw and remove the duct.



7. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    B166453
  1. Disconnect the 2 connectors and remove the instrument panel wire from the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    B166454
  1. Remove the 2 screws.



    B166455E01
  1. Detach the 5 hooks (A).

  1. Detach the 5 hooks (B) and remove the front passenger airbag from the instrument panel.