Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type)

REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK DTC OF AUDIO AND VISUAL SYSTEM
      1. Refer to DTC Check/Clear procedures of the audio and visual system (Click here).
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      GO TO AUDIO AND VISUAL SYSTEM (Click here)
      A


      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM
        1. Refer to the audio and visual system (Click here).
          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B



        B.
        FOLLOW THE AUDIO AND VISUAL SYMPTOM CHART TO PERFORM TROUBLESHOOTING
        A


        7.PROBLEM SYMPTOMS TABLE
        1. Refer to the Problem Symptoms Table (Click here).
          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B



        B.
        ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
        A


        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).


        NEXT


        9.ADJUST, REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END