Home › BODY › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > Wireless-linked Return Function does not Operate

for Preparation Click here


DESCRIPTION

When a door is unlocked by the wireless unlock function, the main body ECU (driver side junction block assembly) receives the door unlock signal and it stores the key ID. When the driver door is opened, the memory call and memory command information of the stored key ID is sent to each driving position related control ECU. Each control ECU receives the memory commands and performs the memory call operation according to predetermined control timing values.

INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

    OK:
    CAN communication DTC is not output.



NG
Go to CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK FRONT POWER SEAT CONTROL SYSTEM
  1. Check the power seat control function (Click here).

  1. Check the seat position memory function (Click here).

  1. Check the seat position restoring function (Click here).

  1. Check the memory call registration function (Click here).
    Result 
    Result
    Proceed to
    OK
    A
    NG (power seat control function)
    B
    NG (seat position memory function)
    C
    NG (seat position restoring function)
    D
    NG (memory call registration function)
    E



B
Go to PROBLEM SYMPTOMS TABLE (Click here)

C
Go to OTHER FLOW CHART (Power Seat Position is not Memorized) (Click here)

D
Go to OTHER FLOW CHART (Power Seat does not Return to Memorized Position) (Click here)

E
Go to OTHER FLOW CHART (Wireless Transmitter Memory Function does not Operate) (Click here)
A


3.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM
  1. Check the wireless lock/unlock function of wireless door lock control system (Click here).

    OK:
    Wireless lock/unlock function operates normally.



NG
Go to WIRELESS DOOR LOCK CONTROL SYSTEM (Click here)
OK


4.REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY
  1. Temporarily replace the position control ECU and switch assembly with a new or normally functioning one (Click here).


NEXT


5.CHECK MEMORY CALL FUNCTION
  1. Perform a seat position memory function (Click here).

  1. Perform a memory call registration function (Click here).

  1. Turn the ignition switch off.

  1. Close and lock all doors.

  1. Unlock the driver door by pressing the unlock switch of the memory call registered key.

  1. Open the driver door and check that the driver seat moves to the memorized position (Click here).

    OK:
    Driver seat moves to the memorized position.



NG
REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
OK

END (POSITION CONTROL ECU AND SWITCH ASSEMBLY WAS DEFECTIVE)