Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1441/41    Air Mix Damper Control Servo Motor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

The air mix damper servo motor (for passenger side) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper (for passenger side) to any position. As a result the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the passenger side is controlled.

DTC Code
DTC Detection Condition
Trouble Area
B1441/41
Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor
  1. Air mix servo motor (for passenger side)
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E147168E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR MIX SERVO MOTOR TARGET PULSE (for Passenger Side))
  1. Use the Data List to check if the servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Air Mix Servo Targ Pulse (P)
    Passenger side air mix servo motor target pulse /
    Min.: 0, Max.: 255
    MAX. COLD: 105 (pulse)
    MAX. HOT: 6 (pulse)
    -

    OK:
    The display is as specified in the normal condition.

    Result 
    Result
    Proceed to
    OK (Checking from the DTC)
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    NG
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE AIR MIX SERVO MOTOR (for Passenger Side)
  1. Temporarily replace the air mix servo motor with a new one (Click here).

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (AIR MIX SERVO MOTOR IS DEFECTIVE) 

4.REPLACE AIR CONDITIONING HARNESS
  1. Replace the air conditioning harness.


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END (AIR CONDITIONING HARNESS IS DEFECTIVE)