TRANSMISSION CONTROL CABLE (for Column Shift Type) > REMOVAL |
| 1. REMOVE STEERING WHEEL ASSEMBLY |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab) |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.
| 3. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.
| 4. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the nut.
Detach the 2 clips and remove the cowl side trim board LH.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
Operate the tilt lever to fully extend and raise the steering column.
![]() |
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Remove the 2 bolts <A>.
Detach the 9 clips, 2 claws and remove the lower instrument panel finish panel sub-assembly LH.
Disconnect each connector.
![]() |
Detach the 3 hooks and disconnect the hood lock control lever from the lower instrument panel finish panel sub-assembly LH.
Pull and slide the hood lock control cable, rotate the hood lock control cable, and then disconnect the hood lock control cable from the hood lock control lever.

| 6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
![]() |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
| 7. REMOVE CENTER LOWER INSTRUMENT COVER |
![]() |
Remove the 2 clips.
Detach the 2 clips, 2 guides and remove the lower center instrument cover.
| 8. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
Detach the 2 claws to remove the lower steering column cover.
| 9. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 10. REMOVE FRONT SEAT ASSEMBLY LH |
for Manual Seat Type:
Remove the front seat LH (Click here).
for Power Seat Type:
Remove the front seat LH (Click here).
for Center Seat:
Remove the front seat LH (Click here).
| 11. REMOVE COLUMN SHIFT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Move the shift lever to N.
Fold back the floor carpet.
Disconnect the column shift transmission control cable end from the column shift.
![]() |
Press the sides of the outer cable socket to detach the claws and disconnect the cable from the steering column shaft bracket.
![]() |
Remove the 2 bolts and disconnect the 2 cable clamps.
![]() |
Remove the nut and clip, and disconnect the transmission control cable from the automatic transmission.
![]() |
Remove the nut and disconnect the transmission control cable support.
![]() |
Remove the 2 bolts and then pull the transmission control cable into the vehicle to remove it.