Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

The combination meter receives engine revolution signals from the ECM via the CAN line. The combination meter displays engine revolution data that is calculated based on the data received from the ECM.

WIRING DIAGRAM


E140490E55


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
Go to CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (TACHOMETER)
  1. Operate the Techstream according to the display and select "Active Test" (Click here).

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Tachometer Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000
    -

    OK:
    Needle indication is normal.

    HINT:
    Confirm that the vehicle is stopped and engine idling.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING TECHSTREAM (TACHOMETER)
  1. Operate the Techstream according to the display and select "Active Test" (Click here).

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed/Min.: 0, Max.: 12750
    Idling: 700 to 800
    Unit: rpm

    OK:
    Engine speed displayed on Techstream is almost the same as actual engine speed.



NG
Go to step 4
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)  

4.READ VALUE USING TECHSTREAM (ENGINE SPEED)
  1. Operate the Techstream according to the display and select "Data List" (Click here).

    Engine and ECT: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0, Max.: 16838.75
    Idling: 700 to 800
    Unit: rpm

    OK:
    Engine speed displayed on Techstream is almost the same as actual engine speed.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 1UR-FE)
    C
    NG (for 3UR-FE)
    D
    NG (for 3UR-FBE)
    E



B
Go to PROBLEM SYMPTOMS TABLE (Click here)

C
Go to PROBLEM SYMPTOMS TABLE (Click here)

D
Go to PROBLEM SYMPTOMS TABLE (Click here)

E
Go to PROBLEM SYMPTOMS TABLE (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)