Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA

RADIO ANTENNA > INSTALLATION

for Preparation Click here



1. INSTALL FENDER ANTENNA ASSEMBLY
  1. Install the fender antenna assembly with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Attach the 5 clamps and install the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect each connector.



2. INSTALL FRONT FENDER LINER RH
  1. Install the front fender liner LH with 13 new grommets.

  1. Install the 4 screws and clip.



3. INSTALL SIDE STEP ASSEMBLY RH (w/ Side Step)

HINT:
Use the same procedure described for the LH side.



4. INSTALL FRONT FENDER MUDGUARD RH (w/ Front Fender Mudguard)
  1. Install the front fender mudguard LH with the 3 screws.

  1. Install the clip.



5. INSTALL ANTENNA ORNAMENT


B355095
  1. Install the antenna ornament as shown in the illustration.



6. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    (Click here)

  1. for Floor Shift Type:
    (Click here)



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT
(Click here)


9. INSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY
(Click here)