VEHICLE STABILITY CONTROL SYSTEM > TRAC OFF Indicator Light does not Come ON |
| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.INSPECT CONNECTOR CONNECTION CONDITION |
Check the skid control ECU connector connection condition.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A17 ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A17-8 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| A17-16 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.PERFORM ACTIVE TEST USING TECHSTREAM (TRC(TRAC) OFF INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Active Test mode and operate the TRAC OFF indicator light using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| TRC(TRAC) OFF Indicator Light | TRAC OFF indicator light*1 TRAC OFF indicator*2 | ON / OFF | Observe combination meter |
Check that the TRAC OFF indicator light*1 or TRAC OFF display*2 on the combination meter assembly turn on or off in accordance with the Techstream operation.
|
| ||||
| OK | |
| 5.INSPECT VSC OFF SWITCH |
![]() |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 - 9 | Switch is pressed | Below 1 Ω |
| Switch is not pressed | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH AND BODY GROUND) |
![]() |
Disconnect the A17 ECU connector.
Disconnect the J22 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-4 (CSW) - J22-9 | Always | Below 1 Ω |
| A17-4 (CSW) - Body ground | Always | 10 kΩ or higher |
| J22-6 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||