Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the blind spot monitor system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT


      4.CHECK CAN COMMUNICATION SYSTEM*
      1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).
        Result 
        Result
        Proceed to
        CAN communication system DTC is not output.
        A
        CAN communication system DTC is output.
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM (Click here)
      A


      5.CHECK FOR DTC AND FREEZE FRAME DATA*
      1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).

      2. Record or print DTCs and freeze frame data, if necessary (Click here).
        Result 
        Result
        Proceed to
        DTCs are output.
        A
        DTCs are not output.
        B



      B.
      Go to step 9
      A


      6.CLEAR DTC*
      1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).

        HINT:
        The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.


      NEXT


      7.RECHECK FOR DTC*
      1. Refer to DTC Check / Clear for the blind spot monitor system (Click here).
        Result 
        Result
        Proceed to
        DTCs are output.
        A
        DTCs are not output.
        B

        HINT:
        Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.



      B.
      Go to step 9
      A


      8.DIAGNOSTIC TROUBLE CODE CHART
      1. Find the output DTC in Diagnostic Trouble Code Chart (Click here).


      NEXT

      Go to step 11


      9.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table.
        A
        Fault is listed in Problem Symptoms Table.
        B

        HINT:
        If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms (Click here).



      B.
      ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
      A


      10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM*
      1. Refer to Terminals of ECU (Click here).

      2. Refer to Data List / Active Test (Click here).


      NEXT


      11.CIRCUIT INSPECTION

        NEXT


        12.ADJUST, REPAIR OR REPLACE

          NEXT


          13.PERFORM BEAM AXIS INSPECTION AND CONFIRMATION
          1. Enter Test Mode (refer to Blind Spot Monitor Beam Axis Inspection) (Click here).

          2. Confirm the blind spot monitor beam axis display and perform the blind spot monitor beam axis adjustment (Click here).


          NEXT


          14.PERFORM CONFIRMATION TEST*

            NEXT

            END