DTC C1AB0 Short to +B in Outer Mirror Indicator(Master) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1AB0 | With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage applied to the indicator is high for a certain amount of time even though the blind spot monitor sensor is not outputting voltage to the indicator. |
|

| 1.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again (Click here).
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR RH CIRCUIT) |
![]() |
Disconnect the blind spot monitor sensor RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S6-4 (OMIR) - Body ground | Ignition switch ON | Below 1 V |
| *a | Front view of wire harness connector (to Blind Spot Monitor Sensor RH) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH) |
![]() |
Disconnect the blind spot monitor sensor RH connector.
Disconnect the M6 outer rear view mirror assembly RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S6-4 (OMIR) - Body ground | Ignition switch ON | Below 1 V |
| *a | Front view of wire harness connector (to Blind Spot Monitor Sensor RH) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH) |
![]() |
Disconnect the blind spot monitor sensor RH connector.
Disconnect the A outer rear view mirror sub-assembly RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S6-4 (OMIR) - Body ground | Ignition switch ON | Below 1 V |
| *a | Front view of wire harness connector (to Blind Spot Monitor Sensor RH) |
|
| ||||
| OK | ||
| ||