Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB1    Short to +B in Outer Mirror Indicator(Slave)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects a +B short in the blind spot monitor indicator LH.

DTC Code
DTC Detection Condition
Trouble Area
C1AB1
With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage applied to the indicator is high for a certain amount of time even though the blind spot monitor sensor is not outputting voltage to the indicator.
  1. Harness or connector
  2. Blind spot monitor sensor LH
  3. Outer rear view mirror assembly LH
  4. Outer rear view mirror sub-assembly LH

WIRING DIAGRAM


E221720E11


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR LH CIRCUIT)


    E263038E24
  1. Disconnect the blind spot monitor sensor LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S5-4 (OMIL) - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Blind Spot Monitor Sensor LH)



NG
Go to step 3
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)  

3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR ASSEMBLY LH)


    E263038E24
  1. Disconnect the blind spot monitor sensor LH connector.

  1. Disconnect the N5 outer rear view mirror assembly LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S5-4 (OMIL) - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Blind Spot Monitor Sensor LH)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH)


    E263038E24
  1. Disconnect the blind spot monitor sensor LH connector.

  1. Disconnect the B outer rear view mirror sub-assembly LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S5-4 (OMIL) - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Blind Spot Monitor Sensor LH)



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK

REPLACE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH (Click here)