Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB2    Short to GND in Outer Mirror Indicator(Master)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a ground short in the blind spot monitor indicator RH.

DTC Code
DTC Detection Condition
Trouble Area
C1AB2
With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage output from the blind spot monitor sensor to the indicator is low for a certain amount of time.
  1. Harness or connector
  2. Outer rear view mirror assembly RH
  3. Outer rear view mirror sub-assembly RH
  4. Blind spot monitor sensor RH

WIRING DIAGRAM


E221720E10


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY RH - BLIND SPOT MONITOR SENSOR RH)


    E280647E02
  1. Disconnect the outer rear view mirror assembly RH connector.

  1. Disconnect the S6 blind spot monitor sensor RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    w/ Memory:
    Tester Connection
    Condition
    Specified Condition
    M6-9 (BSR+) - Body ground
    Always
    10 kΩ or higher
    w/o Memory:
    Tester Connection
    Condition
    Specified Condition
    M6-18 (BSR+) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *A
    w/ Memory
    *B
    w/o Memory
    *a
    Front view of wire harness connector
    (to Outer Rear View Mirror Assembly RH)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH)


    E263038E23
  1. Disconnect the blind spot monitor sensor RH connector.

  1. Disconnect the A outer rear view mirror sub-assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S6-4 (OMIR) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Blind Spot Monitor Sensor RH)



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH (Click here)
OK


4.CHECK OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH
  1. Replace the outer rear view mirror sub-assembly RH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Check for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
OK

END (OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH IS DEFECTIVE) (Click here)