Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB3    Short to GND in Outer Mirror Indicator(Slave)

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects a ground short in the blind spot monitor indicator LH.

DTC Code
DTC Detection Condition
Trouble Area
C1AB3
With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage output from the blind spot monitor sensor to the indicator is low for a certain amount of time.
  1. Harness or connector
  2. Outer rear view mirror assembly LH
  3. Outer rear view mirror sub-assembly LH
  4. Blind spot monitor sensor LH

WIRING DIAGRAM


E221720E11


INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY LH - BLIND SPOT MONITOR SENSOR LH)


    E280647E01
  1. Disconnect the outer rear view mirror assembly LH connector.

  1. Disconnect the S5 blind spot monitor sensor LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    w/ Memory:
    Tester Connection
    Condition
    Specified Condition
    N5-9 (BSL+) - Body ground
    Always
    10 kΩ or higher
    w/o Memory:
    Tester Connection
    Condition
    Specified Condition
    N5-18 (BSL+) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *A
    w/ Memory
    *B
    w/o Memory
    *a
    Front view of wire harness connector
    (to Outer Rear View Mirror Assembly LH)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH)


    E263038E24
  1. Disconnect the blind spot monitor sensor LH connector.

  1. Disconnect the B outer rear view mirror sub-assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S5-4 (OMIL) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Blind Spot Monitor Sensor LH)



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK


4.CHECK OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
  1. Replace the outer rear view mirror sub-assembly LH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
OK

END (OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH IS DEFECTIVE)